; KISSlicer - PRO
; Windows
; version 2 a 2.0.6 Win64
; Built: May 23 2020, 15:05:59
; Running on 16 cores
;
; Saved: 2020-12-01 13:23:17
; 'base.gcode'
;
;
; Calculated-during-export Build Time: 33.25 minutes
; Estimated-in-GUI Build Time:         33.26 minutes
; Estimated-in-GUI Build Cost:         $0.28
;
; Filament used per extruder:
;    Ext #1  =  3682.89 mm  (8.458 cm^3)
;
; *** Extrusion Time Breakdown ***
; * estimated time in [s]
; * before possibly slowing down for 'cool'
; * not including Z-travel
;
;	| Ext #1  | Path Type
;	========================================
;	| 38.7743 | Jump Path                  |
;	| 0       | Pillar Path                |
;	> 0       > Raft Path                  >
;	| 0       | Support Interface Path     |
;	| 0       | Support (may Stack) Path   |
;	| 299.226 | Perimeter Path             |
;	> 229.594 > Loop Path                  >
;	| 1106.33 | Solid Path                 |
;	| 0       | Sparse Infill Path         |
;	| 0       | Stacked Sparse Infill Path |
;	> 31.8528 > Destring/Wipe/Jump Path    >
;	| 130.905 | Crown Path                 |
;	| 12.6117 | Prime Pillar Path          |
;	| 0       | Purge Path                 |
;	> 73.1345 > Travel/Ironing Path        >
;	| 0       | Pause Point                |
;	| 72.6    | Extruder Warm-Up           |
;	========================================
; Total estimated (pre-cool) minutes: 33.25